Mens / Womens Shavers. InCarTec FK-951-NAV-R BMW 3 Series Double Din Stereo Fitting Kit (NAVIGATION/ROUND PIN). Complete fitting kit to install a Double DIN head unit and retain the original steering wheel controls in BMW 3-Series (E46) cars fitted with navigation radio. Double Din Fascia Kit. Female ISO to Male Din Antenna Adaptor Cable. Universal patch lead (Included). Compatible with following vehicles. Car Make / Model. Modification is required to fit a head unit with a Double DIN chassis. We recommend this is done by a skilled car audio technician! Modification to the heater box can be avoided by fitting a radio with a compact/ single DIN rear chassis at the top the radio, such as the SONY XAV-AX3005DB shown below. BELOW IS A PICTURE OF AN AFTERMARKET HEAD UNIT UPGRADE USING THIS FACIA KIT WITH THE ORIGINAL RHD CENTER CONSOLE PANEL MODIFIED TO FIT THE CLIMATE CONTROL MODULE WHERE THE UPPER STORAGE TRAY WAS. This adaptor will convert the non din-sized aperture left after removing the factory stereo to a din size ready for head unit installation. The high quality finish, colour and texture are designed specifically to maintain the original look of your vehicles interior. A stalk/steering wheel control adaptor enables you to utilise the original factory remote audio (whether built onto steering wheel or fitted on a stalk next to the steering wheel) with an aftermarket unit. An Aerial Adaptor is needed when replacing the original factory fitted head unit with an aftermarket head unit. This cable is used to extend the antenna connection by 4.5 metres. Universal patch lead to be used with In car Tec 29- series steering wheel control interfaces. This cable plugs into the 29-Series control box and connects to the 3.5mm socket or single wire on the back of the new head-unit. Suitable for Use with Alpine, Clarion, JVC, Kenwood, Pioneer, Sony, Zenec, Philips, Dynavin and non branded Chinese head units. The fascias are made to suit industry standard sized stereos such as Pioneer, Kenwood, Sony, Alpine, JVC etc, NOT INCLUDING China units or unbranded units. China units have a reputation to be over sized and may require modification to the fascia to allow it to fit. We do not take any responsibility for China units not fitting as they are not industry standard size. Some knowledge of car audio installation is helpful, as in some rare case “modification” is necessary. IMPORTANT NOTE: Please make sure that is the correct fascia for your car by firstly checking to see if your make, model and year of car is listed in the advert. Secondly by checking to see if the shape of the fascia listed looks like your standard stereo.
