Mens / Womens Shavers. V2 Double Din Stereo Upgrade Fitting Kit (RCD300 RCD500). Complete stereo upgrade fitting kit to install a Double DIN aftermarket radio in various Volkswagen cars. This kit fits cars with original RCD300, RCD500 or RNS-MFD-2 radio. This is an alternative product to FK-699-SWC1-T. Double Din Flush Fit Fascia Adapter With Side Fixing Brackets. Radio Replacement Steering Wheel Adapter Interface. Twin Fakra Antenna Adapter (12v Phantom power). Universal patch lead (Included). Compatible with following vehicles. Car Make / Model. This adaptor will convert the non din-sized aperture left after removing the factory stereo to a din size ready for head unit installation. The high quality finish, colour and texture are designed specifically to maintain the original look of your vehicles interior. This fascia kit uses side fixing brackets, the brackets fit directly to the sides of the new radio and the fascia panel. This replaces the need for a fitting cage and gives a flush professional appearance to the installation. Steering wheel control interface and adapter cable for Volkswagen, Seat and Skoda cars to fit an aftermarket radio upgrade. The cable adapts from the Quadlock connector in the car to standard aftermarket ISO connectors. This replaces the need for a separate ISO radio replacement adapter cable. The CANbus steering wheel control interface is built in to the adapter cable for a plug and play installation. This interface will allow the original audio control buttons on the steering wheel to work with the new aftermarket radio. Note; the operation of these buttons can be dependent on the vehicle specification and radio compatibility. The CANbus interface will also provide a key present ignition, illumination, speed pulse, reverse gear and handbrake outputs. No radio information will be shown on the original display in the car. This is an alternative product to 49-VW-01. An Aerial Adaptor is needed when replacing the original factory fitted head unit with an aftermarket head unit. Twin fakra to DIN antenna adapter cable with 12v phantom power. This antenna adapter cable adapts from the original twin fakra connectors in the vehicle to a standard aftermarket radio DIN antenna connection for the fitting of a stereo upgrade. Patch cable set to connect a UNICAN interface between an after market head unit and the steering wheel controls. Can be used with Alpine, Kenwood, JVC (single wire), Pioneer, Sony and Chinese/Resistive learning head units with either two wires or a 3.5mm jack. THIS FITTING KIT IS COMPATIBLE WITH VOLKSWAGEN CARS FITTED WITH ORIGINAL RCD300, RCD500 OR RNS-MFD-2 HEAD UNITS THAT HAVE A TWIN FAKRA ANTENNA CONNECTION, PLEASE SEE PICTURES BELOW. The fascias are made to suit industry standard sized stereos such as Pioneer, Kenwood, Sony, Alpine, JVC etc, NOT INCLUDING China units or unbranded units. China units have a reputation to be over sized and may require modification to the fascia to allow it to fit. We do not take any responsibility for China units not fitting as they are not industry standard size. Some knowledge of car audio installation is helpful, as in some rare case “modification” is necessary. Please make sure that is the correct Fitting Kit for your car by firstly checking to see if your make, model and year of car is listed in the advert. Secondly by checking to see if the connection in the picture listed is the same as you have in your vehicle.
